Brooklyn, NY Appliance Air Conditioning Heating Repair and Service
Brooklyn, NY Appliance, Air Conditioning and Heating Repair
Grapevine Brooklyn, NY Appliance Repair
HOME BRANDS WE REPAIR AREAS WE SERVICE PRICES WARRANTY TESTIMONIALS CONTACT US
 
Home > Brooklyn, NY Dryer Repair

If your gas and electric dryer doesn't dry clothes properly or simply act oddly, we are available to provide a solution for your gas and electric dryer problem immediately. Just call our toll-free number and we will take care of the rest. We are available 24/7 for Brooklyn gas and electric dryer repair at:

800 224-1342

Or, if you prefer, email us at: appointment@brooklynappliancerepairservice.com Please include your name, phone number and a short explanation of your gas and electric dryer issue. As soon as we receive your email, we will contact you with the solution for your gas and electric dryer problem.

We repair all dryer brands

Maytag
Whirlpool
GE
Frigidaire
Speed Queen
Bosch
Hotpoint

Sears
Kenmore
Admiral
Frigidare
RCA
Magic Chef
Ruud

O'Keefe and Merritt
Sunray
Thermador
Wedgewood
Jenn-Air
Sub-Zero
Tappan


And many more dryers that we repair in Brooklyn, NY brands view the full list

Our service area for any gas and electric dryer repair covers the entire Brooklyn area. Please view our extensive service area list below:

Brooklyn
Queens
New York
Elmhurst
Astoria
Jackson Heights
Middle Village

Jamaica
Corona
Union City
Arverne
Far Rockaway
South Ozone Park
Linden Hill

Flushing
Jersey City
Ozone Park
Howard Beach
Jackson Heights
Queens
Madison

View the list of our Brooklyn dryer repair service areas.

The below information is placed here in order to help you get more familiar with your gas and electric dryer and how you may be able extend its life. This information can also tell you how you can use your gas and electric dryer in the most efficient way, which will save you money on your utility bills. However, we do not include this information as a suggestion or recommendation that you perform gas and electric dryer repairs on your own. All gas and electric dryer repairs require experience, professional training and gas and electric dryer repair tools. Repairs for electric and gas gas and electric dryer systems can become very dangerous without the right knowledge, experience and tools. For experienced, professional Brooklyn gas and electric dryer repair help, call us 24/7 at:

800 224-1342

Anatomy of Dryer

Air is drawn in the front bottom of the dryer. It passes around the outside of the dryer basket and enters the system then at the rear of the dryer basket. It will on passes either over the dryer burner flame or over the hot coils of the dryer heater. It is then heated and drawn through holes at the rear of the basket. Inside the basket, the heated air passes around the clothes (pick., up moisture and lint). It is then drawn through holes in the inner dryer door panel, and down through the lint trap. For, the lint is trapped so that it is forced out the dryer exhaust system. The air enters the air duct as it is being pulled by the dryer blower and is forced out the exhaust duct where a biased thermostat measures the air temperature. The air then passes out of the dryer and into the exhaust system to the outside.
Dryer Cycles of Operation
The following is a description of the cycles of operation of a clothes dryer.
This cycle selection allows the user to vary the drying time up to 70 minutes and to determine the temperature setting by adjusting a Separate temperature dryer control switch. The user can choose from four (4) different temperatures: Regular (high), Medium, Low, and Air Fluff (no heat). Once the dryer and temperature selection have been made, the dryer start button must be depressed to start the dryer. One hundred and twenty volts is applied to the dryer drive motor which, in turn, rotates the drum and the blower. As the motor comes up to speed: (1) the centrifugal switch in the motor opens the circuit to the motor run windings; (2) closes a holding circuit which parallels the circuit through the dryer start switch that is closed only while the start button is pressed; and (3) closes a set of contacts to complete a 210-volt circuit through the heating element, to complete a 120-volt circuit to the burner on gas models. (This switch arrangement in the motor is designed to open the heat circuit.) The temperature of the air in the drum will normally be kept between 100 and 180°F when the Regular heat selected. A dryer high limit thermostat is in series with the thermostat to prevent dryer overheating. Approximately 6 minutes before the tinted cycle is complete, the circuit to the heating element or burner will open, permitting the clothes to cool down before the drum stops rotating. This feature helps to reduce wrinkling of the clothes.
Auto-Dry The temperature control dryer thermostat a-high limit thermostat are connected in parallel with the dryer motor. The dryer timer motor is, therefore, shunted out of circuit by the thermostat as long as it is closed. This  prevent the dryer to heat air for an extended period of time until reaches the selected cutout temperature.

You can schedule your same-day Brooklyn, NY dryer repair appointment simply by calling us at:

800 224-1342